Jump to content

Recommended Posts

I was playing with my half shafts the other day and notice two wired going to my gas tank on the passenger side facing the front of the car. One was so lose it fell off with a touch. The connector looked like it would slide onto the terminal on the tank. The terminal on the tank looked like a short stub with a flat hat on on it. My issue is I cannot get the darned wiring connector back on the flat hat!!!

I think my wiring connector is worn out. Is there a place I can buy another connector I can splice in?

I can take pictures if that helps!

Link to comment
https://www.classiczcars.com/topic/29273-gas-tank-terminal-help/
Share on other sites


I ran into that the other day and I had to use a small needle nose pliers to pull the connector up out of the rubber boot, then slide the connector on the stub. Putting the rubber boot back over the connector is a bit difficult. Might try wd40 or something to make it slick.

DOH, good one, I can get pictures, but I think the comments on sliding the boot back to clear the connector is a good one. I was going to try that, but was not sure if the boot moved and did not want to do any damage. I will try that and get back to everyone, WITH pics to help.

  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   2 Members, 0 Anonymous, 1,511 Guests (See full list)

×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.