Precision U-Joint part number 393

[ZWolfe]

Good evening everyone,

I was trying to install the above mentioned U-Joints in my half shafts, but they seem to be a hair long I was only able to get the retaining clip in on one side. Has anyone had a similar problem, any ideas, or do I just need to start over with a different part number or brand. Any suggestions would be appreciated.

Thanks Craig

[Hardway]

Hey Craig. I ran in to this when I was installing my Brute Force solid u-joints in to my half shafts. You have to make sure the u-joint is exactly in the middle and that your yoke is not slightly crushed on the sides. If it is slightly crushed you can you a bench vise to help spread it apart.

[ZWolfe]

Thanks, I'll take a look at that today. I thought the yokes looked like they had a bit of an angle, but I didn't think it was possible that they could have bent. I appreciate your input.