JSM Posted September 2, 2017 Share #1 Posted September 2, 2017 Anyone have their center console out? I need a measurement of the hole (bottom left) so I can replace the rubber boot and center it correctly. I'm hoping this will match up. Unfortunately someone cut up the hole forcing me to use the later rubber instead of the correct one. Or should I just slide the rubber down with it in neutral and use that as the guide? Link to comment https://www.classiczcars.com/topic/58441-need-a-favor-measurement/ Share on other sites More sharing options...
Zed Head Posted September 2, 2017 Share #2 Posted September 2, 2017 1 hour ago, JSM said: measurement of the hole (bottom left) Your posts usually have clarity but this one does not. "Measurement of the hole". From where? Looks about 3/16" in diameter. Link to comment https://www.classiczcars.com/topic/58441-need-a-favor-measurement/#findComment-529431 Share on other sites More sharing options...
JSM Posted September 2, 2017 Author Share #3 Posted September 2, 2017 (edited) Sorry, since my car has no predrilled holes for the later model rubber and flange I need to use, I wanted to get a measurement of one of the holes (lower left) placement on somones existing trans tunnel. If I have one of hole measurements, the other three should fall right in place when I go to install. At this point with no holes at all in my trans tunnel, I'm at a best guess to line it up. Edited September 2, 2017 by JSM Link to comment https://www.classiczcars.com/topic/58441-need-a-favor-measurement/#findComment-529432 Share on other sites More sharing options...
Yarb
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now