drivers side door push pin switch for dome light

[Shawninvancouver]

mine was rusted and got pushed in..need a new one .. does anyone know how i can access the wires from under drivers kick panel?? is it hard? can they be fished out?? are they in the area right by relay for flasher? any ideas???

got it out by foot area...why is drivers 3 wires passenger 2 wires??

Edited July 16, 2021 by Shawninvancouver

[Yarb]

Keys in ignition buzzer?

[Shawninvancouver]

So I can get a switch with 2 wires and put 2 to 1 and a ground ?

[Yarb]

Check the FSM wiring diagram for the correct electrical hookup.

[Shawninvancouver]

Ya.   Got it.  Just says 3 black wires.  Wondering what they connect to ?? Done light buzzer.  Etc??

[Zed Head]

[Shawninvancouver]

Is that switch grounded to the frame? Can I just put all wires that go to it to one contact? As opposed to 3 contact points on the switch ? Very hard to find same switch. 

[jfa.series1]

The switch is not grounded to the frame. One of the three wires is providing power, the other two wires go to (1) the warning buzzer that the key is in the ignition and (2) the dome light. Putting all three wires together will defeat the switch - the buzzer and light will always be activated.

[Shawninvancouver]

Will the power wire be live with key on or straight to battery?

[jfa.series1]

5 hours ago, Shawninvancouver said:

Will the power wire be live with key on or straight to battery?

The power wire should be live all the time so that the dome light comes when either door is opened.

[wal280z]

34 minutes ago, jfa.series1 said:

The FUSED power wire should be live all the time so that the dome light comes when either door is opened.

Jim, had to edit your response.

The fuse is in the fuse block.

From the factory.

(In the spirit of I went downtown, to look for a job... but there was no job)