Trunk hatch lock retainer 280z

[MH77280Z]

Guys, i am hitting another issue. The ZCarDepot do not have the retainer for the hatch lock cylinder. It is a bit thicker than the door ones. Is there some other source or alternate product? They do have a 240z door lock retainer which seems a bit thicker but I have not tried it.

Appreciate some help ...

Edited May 4, 2024 by MH77280Z

[kcpope]

I had the same issue. I think the rear hatch retainer clip is unique to the hatch lock and is a bit bigger.

i ended up ordering this clip and taking a dremel tool and widening the gap to make it fit the lock. Its a bit on the small side, but it did work.

Crown Automotive-2583377 Lock... https://www.amazon.com/dp/B077Z8NKQ6?ref=ppx_pop_mob_ap_share

[Terrapin Z]

CPM shows all the same part number for the clip 240-280

Part number  96809-19700 = discontinued

I have some used ones, but the ZCD one should work fine too. 

 

[MH77280Z]

What about this @kcpope: https://zcardepot.com/products/glove-box-lock-clip-oem-240z-260z-280z?_pos=25&_sid=1782842c3&_ss=r#

@Terrapin Z you have any used ones to sell? i can take one?

[Terrapin Z]

That one you linked to at ZCD is too small for the hatch lock. It is for the early Series One fuel door latch. 

Apparently ZCD didn't offer one my bad ^^   I tried MSA and they list one but it is out of stock. (discontinued, same at Nissan)

I do have this one, as you can see it is the largest clip on the car. A little clean up needed. 

 

 

[MH77280Z]

2 hours ago, Terrapin Z said:

That one you linked to at ZCD is too small for the hatch lock. It is for the early Series One fuel door latch. 

Apparently ZCD didn't offer one my bad ^^   I tried MSA and they list one but it is out of stock. (discontinued, same at Nissan)

I do have this one, as you can see it is the largest clip on the car. A little clean up needed. 

 

 

Let me connect on pm

[Tirnipgreen]

I have a new one if you are still needing one.